This tab allows you to specify the parameter values if any to run the report. See the tab.
Displays parameters of the report with your last-time saved default values, which could be the values saved in this tab last time, or in the Enter Parameter Values dialog or Parameter Settings dialog, or when scheduling the report, and for a web report, could also be the values saved in the Parameters panel. Edit the values according to your requirement. You may specify parameter values in these ways.
If you have not yet set the default values on the server, or if you did but your saved default values cannot fully match the current parameters, all the parameters will use their default values specified in the parameters' definition as the initial values.
If no parameter is used in the report, "No Parameter Needed" will be displayed here.
Use Saved Values
If it is available, you can select the previously saved parameter values to apply to the report and save parameter values for reuse later.
Save as default
Saves current parameter values as the default values for the report. It is a user-report level setting.
This option is an action and it takes effect after the task is submitted. Its initial status is always unselected.
For page reports, this option is available when Enable Setting Default Parameter Values For Page Report is checked in the Profile > Customize Server Preferences > Advanced tab.
For web reports, this option is available when Enable Setting Default Parameter Values For Web Report is checked in the Profile > Customize Server Preferences > Advanced tab.
